These are the instructions to install the IFace interface inside of the Kenwood TS-530s. The installation is very easy.
- On the upperside of the radio, after removing the cover, locate the electronic board called “IF Unit”: this is shown in the following picture. In the same you can also see where you can mount the IFace
with simple double-sided adhesive tape.
- Refer to the following images of the wiring diagram to identify the points where you can weld the cables for the IF, power supply and PTT.
- Refer to the following image to identify the points on the PCB where to weld the various connecting cables.
- Finally connect the coaxial output cable of the IF signal and pass it through the ventilation holes of the radio as shown in the picture.
In order to buy an IFace please use the following buttons.
ATTENTION: Though installing the IFace is not difficult, you do this at your own risk. TSP S.r.l. is not responsible for any damage, unwanted side-effects or whatever.
For more information do not hesitate to write us.
Have fun!