Tag ft-747gx

These are the instructions to install the IFace interface inside of the Ranger RCI-2970N2 in order to add an SDR panadapter to the radio. The installation is very easy.

After removing the cover, locate the main electronic board: the signal we are interested in are on this board. The SDR receiver will be tuned on 10.695 MHz.

Refer to the following image of the wiring diagram to identify the points where you can weld the cables for the IF and the power supply. The PTT+ is not required, the signal paths for the RX and the TX are mostly separated.

Refer to the following images to identify the points on the PCB where to solder the various connection cables between radio and IFace.

In order to buy an IFace please use the following buttons.

ATTENTION: Though installing the IFace is not difficult, you do this at your own risk. TSP S.r.l. is not responsible for any damage, unwanted side-effects or whatever.

For more information do not hesitate to write us.
Have fun!

These are the instructions to install the IFace interface inside of the YAESU FT-747GX in order to add an SDR panadapter to the radio. The installation is very easy.

After removing the cover, locate the electronic board called “MAIN UNIT”: the signal we are interested in are on this board. The SDR receiver will be tuned on 47.055 MHz.

Refer to the following image of the wiring diagram to identify the points where you can weld the cables for the IF and the power supply. The PTT+ is not required, the signal paths for the RX and the TX are mostly separated.

Refer to the following images to identify the points on the PCB where to solder the various connection cables between radio and IFace.

In order to buy an IFace please use the following buttons.

ATTENTION: Though installing the IFace is not difficult, you do this at your own risk. TSP S.r.l. is not responsible for any damage, unwanted side-effects or whatever.

For more information do not hesitate to write us.
Have fun!